#Maglite disassembly instructions manual#

3) : Fixez le corps de lampe dans la tte. 2) Placez la tte, tourne vers le bas, sur une surface plate et stable. Les mini-lampes de poche Mini Maglite peuvent passer rapidement au mode bougie en trois tapes rapides : 1) Dvissez la tte de la lampe. First Edition: November 2006 Version: 1.0 Packard Bell B.V. Step 2: Place head down on stable flat surface.

#Maglite disassembly instructions manual#

Compasseo Disassembly Manual Author: Packard Bell B.V. The document may be used or copied only in accordance with the terms of the agreement. This document is furnished under a nondisclosure agreement. The names of actual companies and products mentioned herein may be (registered) trademarks of their respective owners. Packard Bell is a trademark of Packard Bell B.V. SHALL NOT BE HELD LIABLE FOR TECHNICAL OR EDITORIAL ERRORS OR OMISSIONS CONTAINED HEREIN NOR FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING FROM THE FURNISHING, PERFORMANCE, OR USE OF THIS MATERIAL. No part of this document may be photocopied or reproduced in any form or by any means without prior written consent from Packard Bell B.V. This document contains information protected by copyright. 8 LCD panel and front cover.Р вЂќР Рѓ 6 Notice The information in this document is subject to change without notice. Slightly bend the two clips that hold the LCD panel (see the circles in Fig.

7 The flat cable socket on the mainboard The LCD Panel Follow the steps below to remove the LCD panel: 1. Take the flat cable out of the connector.

Unlock the flat cable lock upwards (see the square in Fig. The bulb in the rear cap was still good but the switch was shot. Mine was so bad I had to pound out the old corroded batteries and wash the cash is baking soda water. Required Tools All disassembly procedures can be performed using the following tools: Small Phillips screwdriverР вЂќР’В§ 5 The Mainboard Follow the steps below to remove the mainboard: 1. Follow the instructions and your mini mag lite will be working. Check that everything is properly installed and tightened. Unduhan Perakitan / Pembongkaran Pistol Otomatis ini membuatnya mudah, berkat keahlian penulis JB, instruksi langkah demi langkah dan fotografi yang. Check that no tools or any loose parts have been left inside the chassis. Bersihkan dan rawat Bernardelli Compact Anda. Use care to ensure that all cables and screws are returned to their proper positions. Reassembly Instructions Reassembly is the reverse of the disassembly process. Label all removed connectors note where the connector goes and in what position it was installed.

Do not disassemble the system into parts that are smaller than those specified in the instructions. Remove the SD or MMC card from the device. Disassembly Instructions When disassembling the system unit, follow these general rules: Turn off the power using the battery switch. Packard Bell reserves the right to make changes to the product without notice. The instructions are illustrated where necessary with images of the part that is being removed or disassembled. 6Р вЂќР в‚¬ 1 Overview This document contains step-by-step disassembly instructions for the Packard Bell Compasseo. 1 Packard Bell Compasseo 300 & 400 Disassembly ManualР вЂќРЎС› Table of Contents Overview.